The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Early V8 (1932-53) (https://www.fordbarn.com/forum/forumdisplay.php?f=4)
-   -   gas pedal linkage 46 48 v8 (https://www.fordbarn.com/forum/showthread.php?t=287457)

mike d 09-19-2020 08:43 AM

gas pedal linkage 46 48 v8
 

does any have diagram or photo of how this goes together at the floor?
is there a seal or a bushing that supports the pedal rod?
thanks

51woodie 09-19-2020 06:07 PM

Re: gas pedal linkage 46 48 v8
 

1 Attachment(s)
Mike. The pedal rod, 9727, "snaps" into the cavity on the underside of the gas pedal, and goes through the firewall into the engine compartment. That rod connects to a spring loaded (throttle return) cross shaft 9725, that bolts to the firewall above the bellhousing. Another rod 9747, connects the cross shaft to the carb throttle. The rods have "spring loaded ends that lock on the ball ends of the respective connections, and there are rubber insulators P/N 91A-9714-A, that go over the ball ends.

mike d 09-19-2020 06:55 PM

Re: gas pedal linkage 46 48 v8
 

thanks much mike;)

mike d 09-19-2020 07:00 PM

Re: gas pedal linkage 46 48 v8
 

do you know of any supplier who stocks those insulators?
thanks again

51woodie 09-19-2020 07:10 PM

Re: gas pedal linkage 46 48 v8
 

Dennis Carpenter or Bob Drake

mike d 09-19-2020 07:22 PM

Re: gas pedal linkage 46 48 v8
 

thanks again

mike d 09-19-2020 08:34 PM

Re: gas pedal linkage 46 48 v8
 

have you seen them in use? thanks

35fordtn 09-19-2020 08:37 PM

Re: gas pedal linkage 46 48 v8
 

As a side note, the 9727 linkage goes through the floor pan not the firewall (there is no seal aside from the fact it passes through the floor mat), and the 9714 insulators are not used when using reproduction linkages.

51woodie 09-20-2020 05:11 AM

Re: gas pedal linkage 46 48 v8
 

Michael. Thank you for correcting the 9727 transition. Also, for the info on original vs repro linkage ends. I must have original linkage, because the rubbers fit my balls. Can I say that?

mike d 09-20-2020 06:33 AM

Re: gas pedal linkage 46 48 v8
 

that was a perfectly acceptable comment


All times are GMT -5. The time now is 07:18 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.