WTB 1957-61 Ford truck 4 spd bellhousing

[hoss73ford]

Pieces before '57 wont work (no holes for clutch slave cylinder) 62-64 takes different starter. Contrary to some beliefs, 3 & 4 speed b/h are diifferent. E-mail: [email protected]

This is needed for a Y block V8 by the way.

[Noswal]

I have a bellhousing with the number TBAB7505 that I think is the bell you are looking for. I would take $50 plus shipping. Shipping from Tennessee may be cost prohibitive. If you are interested, I'll check shipping costs. Thanks.

[hoss73ford]

thats great,,,my zip is 43512 for shipping quotes. Shipping will likely be about $30-40 Im guessing

[Noswal]

hoss73,

You are right on target with shipping costs. It looks like the best rates are at USPS at about $36. I looked at the bell housing again and it looks like there should be a flywheel cover that bolts to the bottom of the bell. I don't have such a cover. Let me know if you still want the bell without the cover. If you want, you can send me a private message and I will send my phone number if you want to talk. Thanks.

[hoss73ford]

the cover is no biggy. I think mechanics must have thrown them away or something, just as long as it is a 4 speed and has the 2 small bolt holes on the upper left corner for the clutch slave cylinder. My email is in my original message. thanks,,,,,Mark

[Noswal]

Sponsored Links (Register now to hide all advertisements)

I don't see any holes for the slave cylinder. This bellhousing was on a 292 that I bought out of a '57 F100. he guy I bought it from pulled the engine. Did some '57's have clutch rod linkage?

[Crestliner]

I have one and it has the 2 bolt holes for the slave cylinder.

[hoss73ford]

hello,,,how much and the cost of shipping to zip 43512?

[Crestliner]

60.00 to your door.

[hoss73ford]

sorry for delayed reply. email me at [email protected]. I'll make the arrangements