The Ford Barn

benbuilder · 04-27-2022, 02:21 PM

I am looking for 30/31 Tudor inner fender panels. Anyone have a line on them?

Thanks

I edited this after i was reminded that i had not included the style.

Oldbluoval · 04-27-2022, 02:26 PM

I likely have a set of repo
Albeit maybe shop worn (dingy,!surface rust)
[email protected]

benbuilder · 04-27-2022, 02:33 PM

I just sent you a pm. please email over picts. [email protected]
thanks
Ben

Oldbluoval · 04-27-2022, 02:44 PM

Missed big question….body style. Coupe, Tudor?

benbuilder · 04-27-2022, 02:52 PM

Right, I did.
Tudor
Thanks

Bill Stipe · 05-07-2022, 09:21 AM

Sponsored Links (Register now to hide all advertisements)

I have started work on stamping out the rear inner fender well for 30-31 Tudor because I need 3 sets and the repro ones are not very good quality. I think my problem will be cost of making the dies again as it was for the 30-31 cowl patches I made. I now have a 100 ton platen press here in Auburn KY so I think that will do the job. I guess time will tell.

04-27-2022, 02:21 PM	#1
benbuilder Member Join Date: May 2020 Posts: 53	1931 tudor inner fender panel I am looking for 30/31 Tudor inner fender panels. Anyone have a line on them? Thanks I edited this after i was reminded that i had not included the style. Last edited by benbuilder; 04-27-2022 at 07:16 PM. Reason: wrong title

04-27-2022, 02:26 PM	#2
Oldbluoval Senior Member Join Date: Jun 2015 Location: Signal Mtn, TN (SE TN) Posts: 2,392	Re: 1931 tudor inner fender panel I likely have a set of repo Albeit maybe shop worn (dingy,!surface rust) [email protected]

04-27-2022, 02:33 PM	#3
benbuilder Member Join Date: May 2020 Posts: 53	Re: 1931 tudor inner fender panel I just sent you a pm. please email over picts. [email protected] thanks Ben

04-27-2022, 02:44 PM	#4
Oldbluoval Senior Member Join Date: Jun 2015 Location: Signal Mtn, TN (SE TN) Posts: 2,392	Re: 1931 tudor inner fender panel Missed big question….body style. Coupe, Tudor?

04-27-2022, 02:52 PM	#5
benbuilder Member Join Date: May 2020 Posts: 53	Re: 1931 tudor inner fender panel Right, I did. Tudor Thanks

05-07-2022, 09:21 AM	#6
Bill Stipe Senior Member Join Date: Aug 2010 Location: Auburn, Kentucky Posts: 198	Re: 1931 tudor inner fender panel Sponsored Links (Register now to hide all advertisements) I have started work on stamping out the rear inner fender well for 30-31 Tudor because I need 3 sets and the repro ones are not very good quality. I think my problem will be cost of making the dies again as it was for the 30-31 cowl patches I made. I now have a 100 ton platen press here in Auburn KY so I think that will do the job. I guess time will tell. __________________ Building Horse Power --