|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-16-2021, 01:00 PM | #1 |
Member
Join Date: Jul 2021
Posts: 76
|
1928 Open Cab Pick-up Wire Routing
Can someone explain the proper way to route the wiring for the rear stop/tail lamp from the rear axle aft to the light out on the bracket. e.g. how do you handle the wiring after the lower frame rail ends by the axle.
Thanks Bob |
09-16-2021, 01:42 PM | #2 |
Member
Join Date: Sep 2013
Location: Central Florida
Posts: 56
|
Re: 1928 Open Cab Pick-up Wire Routing
Don’t know if this is per any judging guidelines, but on my ‘30 OCPU the harness leaves the lower frame, just goes over the axle to a tie-down block behind the axle, then into a flex conduit, to the light.
Tried to attach a couple pics, but the forum is not cooperating. Last edited by Pdgx; 09-16-2021 at 04:00 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
09-17-2021, 02:37 PM | #3 | |
Senior Member
Join Date: May 2010
Location: Portland, Oregon
Posts: 5,902
|
Re: 1928 Open Cab Pick-up Wire Routing
Sponsored Links (Register now to hide all advertisements)
Quote:
__________________
Ray Horton, Portland, OR As you go through life, keep your eye on the donut, not the hole. |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|