|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-23-2020, 07:55 PM | #1 |
Senior Member
Join Date: Apr 2013
Posts: 293
|
Crankshaft Tool
Does anyone know where I can get one of the tools to turn crankshaft when engine is sitting vertical when aligning flywheel housing?? Anyone have one for sale??
|
03-23-2020, 08:23 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,755
|
Re: Crankshaft Tool
The vendors have them. https://www.snydersantiqueauto.com/P.../model-a/tools
|
Sponsored Links (Register now to hide all advertisements) |
|
03-23-2020, 08:43 PM | #3 |
Senior Member
Join Date: Apr 2013
Posts: 293
|
Re: Crankshaft Tool
A good start but would need to be modified for dial indicator to be centered. Could cut out the center nut and weld a couple of half inch 90 degree pipe fittings on the outer edges for extension handles. Thanks, may give this a try.
|
03-23-2020, 08:51 PM | #4 |
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,849
|
Re: Crankshaft Tool
You could try one of these bad boys... a little more expensive. https://www.snydersantiqueauto.com/P...earchByKeyword or make your own out of an old starter.
Or use a 1⅜"wrench on the ratchet nut on the other end of the crank. |
03-23-2020, 09:29 PM | #5 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,755
|
Re: Crankshaft Tool
Is this what your looking for??
|
03-24-2020, 08:28 AM | #6 |
Senior Member
Join Date: May 2017
Location: Huntington Beach, Calif
Posts: 330
|
Re: Crankshaft Tool
Sponsored Links (Register now to hide all advertisements)
|
03-24-2020, 09:22 AM | #7 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,755
|
Re: Crankshaft Tool
Krw a320
|
03-24-2020, 09:34 AM | #8 |
Senior Member
Join Date: Apr 2013
Posts: 293
|
Re: Crankshaft Tool
|
03-24-2020, 10:48 AM | #9 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,046
|
Re: Crankshaft Tool
What's wrong with just using a socket on the crankshaft pulley nut?
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
03-24-2020, 06:04 PM | #10 |
Senior Member
Join Date: Apr 2013
Posts: 293
|
Re: Crankshaft Tool
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|