|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-14-2010, 01:17 PM | #1 |
Senior Member
Join Date: May 2010
Posts: 893
|
valve adjustment before I install heads?
I have adjusted all the valves in the sequence according to Pages 1933 book. By that I mean when a certain two valves are open you adjust these 6. and so forth. I adjusted them to .012 that was my recollection going back to the 70's when I did my last one. It is a 21 stud LB block, johnson lifters, and a 21A cam. Anybody on their lunch hour at the moment. I want to put the heads on after lunch. Thanks in advance. Fred
|
12-14-2010, 05:48 PM | #2 |
Senior Member
Join Date: May 2010
Location: oroville ca.
Posts: 1,554
|
Re: valve adjustment before I install heads?
.012 for in .014 for ex, but check manufactor for settings, some use different settings than a stock ford cam
Last edited by ford1; 12-15-2010 at 01:08 AM. |
Sponsored Links (Register now to hide all advertisements) |
|
12-14-2010, 10:00 PM | #3 |
Senior Member
Join Date: May 2010
Posts: 893
|
Re: valve adjustment before I install heads?
I was asking because the book I used was 1933. They said between 11 and 12 thousands. The cam I used is a n.o.s. 21A-6250 which is 1942-48. I was not sure if there would be a diffrence. I will be using a cam adapter to the dist. If someone thinks the 42-48 cam is different let me know Thanks.
|
12-15-2010, 12:00 AM | #4 |
Senior Member
Join Date: May 2010
Location: Santee, California
Posts: 3,505
|
Re: valve adjustment before I install heads?
As stated above, 12 intake 14 exhaust. I would put each valve on the heal of the cam for adjustment. Less chance of screwing it up when doing intake and exhaust at different lashes.
|
12-15-2010, 12:38 AM | #5 |
Senior Member
Join Date: May 2010
Posts: 114
|
Re: valve adjustment before I install heads?
Is the setting still the same when using the new stainless steel straight stem valves?
|
12-15-2010, 02:12 AM | #6 |
Junior Member
Join Date: Jul 2010
Posts: 29
|
Re: valve adjustment before I install heads?
Sponsored Links (Register now to hide all advertisements)
|
12-15-2010, 07:51 AM | #7 |
Senior Member
Join Date: May 2010
Location: Gerrardstown, WV
Posts: 2,266
|
Re: valve adjustment before I install heads?
|
12-15-2010, 10:35 PM | #8 |
Senior Member
Join Date: May 2010
Location: Oshkosh, Wi
Posts: 4,526
|
Re: valve adjustment before I install heads?
|
12-15-2010, 11:49 PM | #9 |
Senior Member
Join Date: May 2010
Location: oroville ca.
Posts: 1,554
|
Re: valve adjustment before I install heads?
no matter what valve you use the settings stay the same, only time they will be different is when you change the cam, then the manufactor may have different setting for the valves
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|