|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-26-2011, 11:22 AM | #1 |
Junior Member
Join Date: May 2010
Location: West Michigan
Posts: 26
|
1929 roadster quarter panel flange to sub frame request
Had to patch both wheel wells along with lower quarter panels. The panels are clamped in place oon the new sub frame, looks good to go but... Does anyone have pictures showing the quarter panel flange area attaching onto the sub frame. Know the original metal flange was notched about an inch in length. But my quarter were in rough shape, only had this on one little section.Would be nice if there was supporting information before cutting the metal flange area. the flange needs to be trimmed as it is to long to crimp to sub frame. Any instructions on how to create a clean flange.
|
09-27-2011, 07:07 AM | #2 |
Senior Member
Join Date: Sep 2010
Location: MADISON, OHIO
Posts: 134
|
Re: 1929 roadster quarter panel flange to sub frame request
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|