|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-23-2020, 10:25 PM | #1 |
Senior Member
Join Date: Nov 2010
Location: SPRUCE PINE NC
Posts: 446
|
Engine oil level question
I changed the oil on a 29 Tudor.
Les Andrews Handbook states that it will take 4-1/2 quarts when changing the oil. I put in a little over 4 quarts and the dip stick shows about 3/16" over the full mark. Question is: Do I add another 1/2 quart and remark the dip stick? OR what?
__________________
Why is there never enough time to do it right, but always enough time to do it over!!! |
05-23-2020, 10:35 PM | #2 |
Junior Member
Join Date: Aug 2019
Location: West Haven, Connecticut
Posts: 19
|
Re: Engine oil level question
Could possibly have some sludge build up in there hence the reason at 4 quarts your already over the mark I did my oil change last week at 4.5q I was right on the full line.
|
Sponsored Links (Register now to hide all advertisements) |
|
05-23-2020, 11:58 PM | #3 |
Senior Member
Join Date: Jan 2012
Location: Tx
Posts: 502
|
Re: Engine oil level question
There is some oil that stays in the pan. Some one can explain it better then me.
I usually put in 4 qts on a oil change. |
05-23-2020, 11:58 PM | #4 | |
Senior Member
Join Date: May 2010
Location: Young Harris, GA
Posts: 1,821
|
Re: Engine oil level question
Quote:
If you overfill the engine, the rear main seal will usually leak more.
__________________
Jim Cannon Former MAFCA Technical Director "Have a Model A day!" |
|
05-24-2020, 06:48 AM | #5 | |
Senior Member
Join Date: Sep 2016
Location: Roanoke, VA USA
Posts: 1,908
|
Re: Engine oil level question
Quote:
I never thought about sludge potentially taking up space in the oil pan and altering the amount of oil required for a refill. My car’s engine was rebuilt before I purchased it; so, I’ve never had the pan off. Can sludge really build up that much? Sent from my iPhone using Tapatalk |
|
05-24-2020, 09:39 AM | #6 |
Senior Member
Join Date: Jun 2014
Location: Land of Lincoln
Posts: 3,131
|
Re: Engine oil level question
Sponsored Links (Register now to hide all advertisements)
__________________
Don't force it with a little hammer tap, tap, tap get a bigger hammer tap done |
05-24-2020, 02:29 PM | #7 |
Senior Member
Join Date: May 2010
Location: new britain,ct 06052
Posts: 9,390
|
Re: Engine oil level question
Over decades............and by not changing at 500-1000 miles. JMO
Paul in CT |
05-24-2020, 05:07 PM | #8 |
Senior Member
Join Date: Jul 2015
Location: SouthWest Michigan
Posts: 363
|
Re: Engine oil level question
If you just run it
It will find it's own level Just keep an eye on it It will be fine Sent from my iPhone using Tapatalk |
05-25-2020, 08:26 AM | #9 | |
Senior Member
Join Date: Aug 2018
Posts: 2,332
|
Re: Engine oil level question
Quote:
After a 50 year nap, my A had inches of sludge built up in the bottom of the pan, had buildup in the Valve Galley, and had actually blocked the oil pump and oil pump screen. Luckily I caught it before it caused damage to the motor. It is the nastiest black/brown goo like molasses substance ever. Once on your hands or clothes is very difficult to clean off. Since multi-weight oil keeps contamination floating around in the oil, this is the reason some like to add the aftermarket oil filter kit. Other contributors to sludge. In the history of oil, manufacturers added Paraffin to motor oil to quiet valves and worn motors. Paraffin is wax. I believe this was in the 50s/60s Motor coolant temps need to reach 160 degrees or more to allow the oil to reach temps that burn off condensation and other contaminants. Usually for more than 20 minutes. Some of us like to install a thermostat for this reason, and lubrication works better at higher temps, and the thermostat allows the temp to reach operating much quicker. Most wear happens at cold/lower motor temps. Since your motor was rebuilt, your motor should be clean, especially since after rebuild it most likely has been using detergent oil. |
|
05-25-2020, 08:37 AM | #10 |
Senior Member
Join Date: Aug 2018
Posts: 2,332
|
Re: Engine oil level question
deleted double post
Last edited by 30 Closed Cab PU; 05-25-2020 at 02:20 PM. Reason: double post |
05-25-2020, 11:57 AM | #11 |
Senior Member
Join Date: Nov 2010
Location: SPRUCE PINE NC
Posts: 446
|
Re: Engine oil level question
New engine with zero miles--sludge is not an issue.
__________________
Why is there never enough time to do it right, but always enough time to do it over!!! |
05-25-2020, 12:08 PM | #12 | |
Senior Member
Join Date: Nov 2010
Location: SPRUCE PINE NC
Posts: 446
|
Re: Engine oil level question
Quote:
So how much oil goes in after draining out old oil? Andrews says 4-1/2 quarts.
__________________
Why is there never enough time to do it right, but always enough time to do it over!!! |
|
05-26-2020, 06:39 AM | #13 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: Engine oil level question
You are going to have at least 1/2 quart (1 pint) left in the engine after changing the oil.
The engine capacity is 5 quarts. So on refilling, put in 4-1/2 quarts. That will get you to your 5 quart capacity. I hate "guessing" at just how much is in the engine when I check it so I have marked my dipstick. For every quart added, there is a mark. Some may not recommend this and that is OK...It works for me. Just remember when you do this, that there is a 1/2 quart of oil in the engine already that must be accounted for. Pluck |
05-26-2020, 06:57 AM | #14 |
Senior Member
Join Date: Apr 2013
Location: Northwest CT
Posts: 1,092
|
Re: Engine oil level question
Is it an original or repro dipstick?
|
05-26-2020, 08:53 AM | #15 |
Senior Member
Join Date: Feb 2015
Location: Georgetown, TX
Posts: 535
|
Re: Engine oil level question
Half quart or so stays in the dipper pan when you drain your oil. Never overfill!
|
05-27-2020, 12:41 PM | #16 |
Senior Member
Join Date: Dec 2014
Location: Shawnee, Ok
Posts: 3,471
|
Re: Engine oil level question
Oil capacity is five quarts, tray hold 1/2 quart, 4.5 quarts at oil change,
If you have no sludge in the pan. At your next oil change run your pinky finger in the drain hole and "finger out" how much sludge is in there.
__________________
Keith Shawnee OK '31 SW 160-B |
|
|
Sponsored Links (Register now to hide all advertisements) |
|