|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-21-2014, 09:10 AM | #1 |
Member
Join Date: Sep 2013
Location: Fort Jones, Calif
Posts: 94
|
Castle nuts and correct torque
An old question I'm sure, but I'll run it by once again. After getting the correct torque on the mains, I noticed that some holes for the wire don't line up. I did a search here and found this from a few years back. Would I be good to go with Kurt's post?
This is a 1948 '59' block. http://www.fordbarn.com/forum/showth...tle+nuts+crank
__________________
Darol |
|
|
Sponsored Links (Register now to hide all advertisements) |
|