A and AA flywheel castings

[JOHNCL]

I have several flywheel cover castings for Model As and they have the side mount provisions for the frame mounts. I also have what I think is an AA flywheel cover and bell housing, with a socket on the bottom for the wishbone ball and the flange for a truck 4 speed transmission. but it does not seem to have side mount provisions like those on a car's casting. Is it supposed to bolt to the car-type casting, or what?

[jerrytocci]

could be tractor

[Bob C]

The AA uses the same flywheel housing as the A, the picture is an AA clutch housing.

[40 Deluxe]

Originally Posted by jerrytocci

could be tractor

No Ford tractor ever used a Model A engine or bell housing. There were some aftermarket tractors such as the Worthington mowers that used regular Model A stuff and industrial/agricultural power units based on the A but no Ford factory built tractors based on the A.

[Richard in Anaheim CA]

I have always called that housing the bell housing which is bolted to the clutch or flywheel housing which has the mounting attachments to the frame.

[Purdy Swoft]

Sponsored Links (Register now to hide all advertisements)

Originally Posted by Richard in Anaheim CA

I have always called that housing the bell housing which is bolted to the clutch or flywheel housing which has the mounting attachments to the frame.

Right on , I agree .

[SteveB31]

It is likely for later then Model A. The 4 speed transmission was used for 30 years, but had different clutch housings for each year it was used. If you posted a photo, I could likely identity it for you.

[Bob C]

I've always called it a bell housing also but Ford called it a clutch housing 7501.

[JOHNCL]

Thank you all for your responses. I will verify in the next few days.