|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-08-2017, 01:38 PM | #1 |
Senior Member
Join Date: May 2012
Location: Lafayette, La.
Posts: 181
|
!941 Ford Coupe vent Window
Is it possible to have a glass cut to fill the opening of the vent window and window there by eliminating the vent window?? Sorry that is for the front and passenger door ??THANKS Jerry
Last edited by albjerryg; 09-08-2017 at 02:03 PM. |
09-08-2017, 01:51 PM | #2 |
Senior Member
Join Date: Dec 2015
Posts: 287
|
Re: !941 Ford Coupe vent Window
I'm not sure about '41, but in'46 some models had a rear vent window that did not open. I don't know if the rubber seal is still available for these models. Check with some of the suppliers.
|
Sponsored Links (Register now to hide all advertisements) |
|
09-08-2017, 02:08 PM | #3 | |
Senior Member
Join Date: May 2010
Location: Sugar Land, TX
Posts: 4,395
|
Re: !941 Ford Coupe vent Window
Quote:
Untitled by philip sauber, on Flickr
__________________
41 woodie https://41fordwoodie.weebly.com/ |
|
09-08-2017, 02:57 PM | #4 |
Senior Member
Join Date: May 2012
Location: Lafayette, La.
Posts: 181
|
Re: !941 Ford Coupe vent Window
So if I understand you put a permanent glass in the vent that use to pivot. I was thinking of a glass that would roll up and down and cover the window and vent window area? Thanks Jerry
|
09-08-2017, 04:16 PM | #5 |
Member Emeritus
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
|
Re: !941 Ford Coupe vent Window
So your wanting to make it like say a 38/39 door window?
|
09-08-2017, 07:05 PM | #6 |
Senior Member
Join Date: May 2012
Location: Lafayette, La.
Posts: 181
|
Re: !941 Ford Coupe vent Window
Sponsored Links (Register now to hide all advertisements)
|
09-08-2017, 07:28 PM | #7 |
Senior Member
Join Date: Jun 2012
Location: Long Island,NY
Posts: 1,555
|
Re: !941 Ford Coupe vent Window
If I'm reading your question correctly you want to remove the vent window and have a one piece glass. A lot of hot rodders do this, so I would ask the question on the HAMB. A couple of companies that come to mind are Specialty Power Window and Electric-Life. I don't know if your stock crank style equipment will be able to handle a larger window and you will have to fabricate a track for the front of the door.
|
09-08-2017, 08:51 PM | #8 |
Senior Member
Join Date: May 2012
Location: Lafayette, La.
Posts: 181
|
Re: !941 Ford Coupe vent Window
OK thanks for the info and I will contact them. Jerry
|
09-08-2017, 08:59 PM | #9 |
Senior Member
Join Date: May 2012
Location: Lafayette, La.
Posts: 181
|
Re: !941 Ford Coupe vent Window
Does any one know the dimensions of the 1938 Ford coupe front door window glass< ?Thanks Jerry
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|