1930 Murray 4 Door Project

[Casey J]

***SOLD***

Selling off my Model A more door project; I believe it is a 1930 Murray. I'd like to sell it all in one lot, but if no one is interested I will part it out. It is titled as a 2010 Homemade Ford Model A 4 door (ID number is stamped into the frame rail). ID number was assigned by the state of ND.

$700 OR BEST OFFER cash. Local pickup only. The parts are located 40 miles Northwest of Fargo, ND, near Erie, ND.

I'll post the couple pics I have on my computer and will try to get some more up shortly.

Here is what I got:

- Cowl w/ visor– a little rust-through on the sides

- Header panel – a few spots of rust-through

- Rear Section – some rust-through on the wheel wells

- Drivers-side roof panel (above the doors)

- Front doors – drivers and passengers, some rust-through on the bottoms, drivers-side is a little dented up (see pics)

- Rear doors – 3 drivers and 1 passengers

- A couple sets of hinges (in addition to what is currently on the doors/cowl/rear section)

- 2 sets of B pillars

- Frame rails and rear cross member - frame rails are pretty beat up, but still useable. The rear cross member is probably junk. Lots of cracks and farmer welds

[Casey J]

3 day bump...

Open to offers. Would also be interested in a trade for an early 50s Ford or Chevy.

More pics to come this weekend.

[Casey J]

Weekend bump and more pics.

[Casey J]

More pics...frame and roof panel

[Casey J]

$650 or best offer

[Beau Dirt]

Sponsored Links (Register now to hide all advertisements)

I emailed you mine a while back.

I'd give you $300 for the two front doors, cowl and rear section.