1957 FORD t-bird cast valve covers

[ALLTIN33]

I need the outside length and out side width of 1957 FORD t-bird cast valve covers.

[Patrick brophy]

Originally Posted by ALLTIN33

I need the outside length and out side width of 1957 FORD t-bird cast valve covers.

I just so happen to have a set that are loose,,give me an hour or so.

[ALLTIN33]

Thanks

[ALLTIN33]

You can make you own a bolt 5/16 5 " long grade 5 or 8 course thread with shoulder on top cut to length and use fine die cut your own thread. That's what I'll do.

[Patrick brophy]

Originally Posted by Patrick brophy

I just so happen to have a set that are loose,,give me an hour or so.

My hour and the wife's differ.........That said,

length long ways is 19 inches 1/8 ,sideways is 5 inches 3/8.

[ALLTIN33]

Sponsored Links (Register now to hide all advertisements)

Thanks for answer The Fenton covers (from the 50s) I have are "18 13/16 long "5 7/16 wide . looks like I'll order a set of gaskets for cast. And modify the gasket . Or could they be same gasket that fits metal and cast?

[paul2748]

Same gaskets fit metal and cast. The only difference you may run into is that the gaskets for late steel covers had tabs on them. Just cut off.

Originally Posted by ALLTIN33

Thanks for answer The Fenton covers (from the 50s) I have are "18 13/16 long "5 7/16 wide . looks like I'll order a set of gaskets for cast. And modify the gasket . Or could they be same gasket that fits metal and cast?