|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-21-2015, 01:17 PM | #1 |
Senior Member
Join Date: Jul 2012
Location: Central Maine
Posts: 644
|
29 roadster door panels
I'm tired of looking at the tear in my interior door panels where the door handle assembly pokes thru. Whoever did the job just cut the material with a knife. The handle screws on the square rod fine but it looks like there is a 1/4" gap between the panel and handle. Is there supposed to be a piece of trim to take up the space and cover the cut in the panel fabric ? Appreciate your help. Bill
|
11-21-2015, 02:58 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,749
|
Re: 29 roadster door panels
Sponsored Links (Register now to hide all advertisements)
"The door handle was backed by a dull nickel plated flat washer or "escutcheon" measuring 7/8" x 1/16" thick." Bob |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|