|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-09-2021, 07:48 PM | #1 |
Senior Member
Join Date: Feb 2014
Location: Florida - 32128
Posts: 416
|
Lighting switch assembly
I installed a new two section metal enclosure for my original lighting terminal disk. I can’t get power to the running light wires. Using the foreign made two piece enclosure - I ground down the enclosure.035 thousands inch. as noted on the installation guide note. The lighting handle is a little hard to turn (high - low - park). What could be a solution ? Maybe the metal fork is c ringed” to high on the main shaft. it is at 6:00 and 12:00 o’clock.
Last edited by dlfrisch; 02-09-2021 at 07:50 PM. Reason: Spelling |
02-09-2021, 07:59 PM | #2 |
Senior Member
Join Date: Oct 2013
Location: Syracuse,NY
Posts: 264
|
Re: Lighting switch assembly
Sponsored Links (Register now to hide all advertisements)
It may not be the right thing to do but it was for me. Sand a little then try the switch. Repeat as necessary to get the switch to work. |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|