The Ford Barn

steamgas · 01-19-2018, 08:14 AM

can someone describe the function of the oil baffle (part # 6524)? there are 2 of theses parts in the engine just under the carb manifold that are attached by spring force to the oil galley tube.

flatheadmurre · 01-19-2018, 08:19 AM

There are a couple of holes under them if the baffles aren´t there you´ll have more oil splashing around in the valvearea then wanted.

Terry,OH · 01-19-2018, 08:21 AM

They help to control the flow of oil in the valve area. Without them you could find excessive oil consumption. There are a couple of slightly different designs from ford. Make sure to get the correct year and if they have the "F" stamped mount the F toward the front of the engine.

steamgas · 01-19-2018, 08:34 AM

thanks guy's this helps a lot. i was going to make my own oiling system for the valves but you all say that the splash system is all it takes to get the right amount of oil up there. when i first saw that there were on oiling system for the valves i was very concerned about this. Henry ford engineers
done what they could at the time with what they had to work with.

JSeery · 01-19-2018, 11:23 AM

Sponsored Links (Register now to hide all advertisements)

Don't think a lack of oil to the valve spring, lifter area in the valley is an issue, too much oil can be! Increasing oil flow into the valley area would not be a good idea. In a high performance application you would be doing things to get the oil out of the valley area as quickly as possible.

01-19-2018, 08:19 AM	#2
flatheadmurre Senior Member Join Date: Apr 2015 Location: Sweden Posts: 3,045	Re: Need information on an engine part There are a couple of holes under them if the baffles aren´t there you´ll have more oil splashing around in the valvearea then wanted.

01-19-2018, 08:21 AM	#3
Terry,OH Senior Member Join Date: May 2010 Posts: 4,751	Re: Need information on an engine part They help to control the flow of oil in the valve area. Without them you could find excessive oil consumption. There are a couple of slightly different designs from ford. Make sure to get the correct year and if they have the "F" stamped mount the F toward the front of the engine.

01-19-2018, 08:34 AM	#4
steamgas Senior Member Join Date: May 2010 Location: va Posts: 138	Re: Need information on an engine part thanks guy's this helps a lot. i was going to make my own oiling system for the valves but you all say that the splash system is all it takes to get the right amount of oil up there. when i first saw that there were on oiling system for the valves i was very concerned about this. Henry ford engineers done what they could at the time with what they had to work with.

01-19-2018, 11:23 AM	#5
JSeery Member Emeritus Join Date: Nov 2012 Location: Wichita KS Posts: 16,132	Re: Need information on an engine part Sponsored Links (Register now to hide all advertisements) Don't think a lack of oil to the valve spring, lifter area in the valley is an issue, too much oil can be! Increasing oil flow into the valley area would not be a good idea. In a high performance application you would be doing things to get the oil out of the valley area as quickly as possible.