|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-12-2014, 12:58 PM | #1 |
Member
Join Date: Mar 2012
Location: Temuka New Zealand
Posts: 49
|
fitting sill plate brackets to sub frame 28-9 model
Hi folks ,haw are the sill plate brackets fitted to the sub frame of a 28-9 roadster pick up, I have a new sub frame ,so it has no holes to show where thay go.Hope someone can help. Cheers Gerry.
|
08-12-2014, 05:15 PM | #2 |
Senior Member
Join Date: May 2010
Location: Lakeville, MN
Posts: 5,159
|
Re: fitting sill plate brackets to sub frame 28-9 model
If you could post a picture or two of the area you are having questions about, that would help get some answers.
Rusty Nelson |
Sponsored Links (Register now to hide all advertisements) |
|
08-13-2014, 04:18 AM | #3 |
Member
Join Date: Mar 2012
Location: Temuka New Zealand
Posts: 49
|
Re: fitting sill plate brackets to sub frame 28-9 model
Hi.On the 28-9 roadster pickup there is a sill plate,becouse this is quite flimsy,
it has a bracket that fits onto the sub frame to make a stronger sill plate when stood on. This bracket is bent up to fit the contour of the sub frame,Iam not sure if this just sits there held on by the sill plate screws or it has separate bolts or rivets that conect to the sub frame. Hope this will help .Cheers Gerry. |
08-13-2014, 12:08 PM | #4 |
Member
Join Date: Mar 2012
Location: Temuka New Zealand
Posts: 49
|
Re: fitting sill plate brackets to sub frame 28-9 model
bump
|
08-13-2014, 04:17 PM | #5 |
Senior Member
Join Date: May 2010
Location: Georgetown Divide Kelsey ca
Posts: 868
|
Re: fitting sill plate brackets to sub frame 28-9 model
If you post a photo of the area where you have a question help will be a lot faster . I have a 28 pickup and could take photos .
__________________
Dennis in Kelsey ca |
08-13-2014, 07:25 PM | #6 |
Senior Member
Join Date: May 2010
Posts: 1,640
|
Re: fitting sill plate brackets to sub frame 28-9 model
Sponsored Links (Register now to hide all advertisements)
Here's some pictures of a cowl where the sub frame and the bracket have been cut through - should show you what you need to line things up. Also an underside view of an original sill panel which was wrapped under but not crimped to the lower outside edge of the sub frame. Main consideration here is to try to get the reveals on the cowl, the door sill and the rear panel to line up. |
08-14-2014, 04:18 AM | #7 |
Member
Join Date: Mar 2012
Location: Temuka New Zealand
Posts: 49
|
Re: fitting sill plate brackets to sub frame 28-9 model
Hi folks,many thanks for your help .This will be a great help.Iam sorry I couldn't send any photos as my camera was away.
Cheers Gerry. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|