|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-21-2021, 10:22 AM | #21 |
Junior Member
Join Date: Dec 2020
Posts: 11
|
Re: Steering box bottom tube seal?
Andy I thought I had a line on an NOS steering box end plate with the tube but it turns out it was the wrong size and I’m back to square one.
I have a 37 ford 1/2 ton pickup and I am in need of the 4 hole end plate with brass tube. Any chance you can hook me up? Thanks. Mitch |
01-21-2021, 09:07 PM | #22 |
Junior Member
Join Date: Dec 2020
Posts: 11
|
Re: Steering box bottom tube seal?
Hey Andy,
I received your response but the Ford Barn site would not allow me to send you a PM because I am new to the sight and do not have enough posts yet so I must contact you this way. That being said I would very much like a plate and $20 plus shipping would be great. I can easily drill my shaft out bigger that would not be a problem as I already have the shaft out as I had to completely rebuild my steering box. I’ll give you my address so you can calculate the shipping and just let me know how you would like to get paid. I can do PayPal, Venmo or mail you a check just let me know. Thanks Mitch Mitch LaCombe 5016 44th Ave So Minneapolis, Mn 55417 |
Sponsored Links (Register now to hide all advertisements) |
|
01-22-2021, 07:12 PM | #23 |
Senior Member
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,769
|
Re: Steering box bottom tube seal?
I have a four hole flange and I will use it to make your part. I will see what the cheapest shipping will be. Thanks
|
01-27-2021, 03:30 PM | #24 |
Senior Member
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,769
|
Re: Steering box bottom tube seal?
I did a 2 hole and a 4 hole. They are slid on a 32 horn rod and also in a 32 steering shaft. All move freely. The steering shaft was drilled out 1/64" for a couple of inches. I show the jig for soldering
Last edited by Andy; 01-27-2021 at 04:10 PM. |
01-27-2021, 09:19 PM | #25 |
Junior Member
Join Date: Dec 2020
Posts: 11
|
Re: Steering box bottom tube seal?
Andy,
That looks great. I’d take the 4 hole. Just tell me the total and how you’d like to get paid. Venom, paypal or I could mail you a check. Thanks, Mitch |
01-28-2021, 10:06 AM | #26 |
Senior Member
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,769
|
Re: Steering box bottom tube seal?
Sponsored Links (Register now to hide all advertisements)
|
01-28-2021, 03:06 PM | #27 |
Junior Member
Join Date: Dec 2020
Posts: 11
|
Re: Steering box bottom tube seal?
Thanks Andy,
Payment was sent. I am looking forward to receiving it. I truly appreciate your efforts. Thanks again, Mitch |
01-28-2021, 05:10 PM | #28 |
Senior Member
Join Date: May 2010
Location: Kerrville, Tx
Posts: 2,769
|
Re: Steering box bottom tube seal?
PM sent
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|