Model A Engine/Trans Removal questions

[Tulsa]

I did some searching, but I always suck at search. I am pulling the motor and trans from the 30 model a. I will not need motor mounts. The front mount and mid mount look simple. but, the front control arms are attached to the transmission. Will I be able to roll around the chassis when I remove those? Also is the only other rear mount the closed DS?

Are there any threads with a write up?
__________________

[BRENT in 10-uh-C]

Sponsored Links (Register now to hide all advertisements)

I don't know about a thread here listing it as a step-by-step procedure but there is a Repair Manual available that might be good for you to have. The chassis can still be moved with the front radius rod disconnected from the clutch housing however it will be loose. The driveshaft torque tube will generally rest on the service brake cross-shaft after the engine/transmission have been removed.