|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
01-17-2022, 09:38 AM | #1 |
Senior Member
Join Date: Feb 2011
Location: De Pere, WI
Posts: 290
|
Late 31 Tudor Windshield Filler Trim Question
Hey everyone,
I have an original filler trim that is rotted out. It has or "had" cage nuts that run along it. I purchased a replacement filler trim from Snyder's and it has no cage nuts or any holes at all. I am wondering what procedure those have followed when using a repro filler trim? Do these holes and cage nuts need to be added? Thanks in advance! - Travis |
01-17-2022, 09:59 AM | #2 |
Senior Member
Join Date: May 2010
Location: Innisfil, Ontario Canada
Posts: 1,174
|
Re: Late 31 Tudor Windshield Filler Trim Question
If this is the part that goes along the top of the gas tank, yes you will need to drill the holes. you can bolt most of it but it will get tricky at the ends. The cage nuts make it easier to install.
|
Sponsored Links (Register now to hide all advertisements) |
|
01-17-2022, 01:40 PM | #3 |
Senior Member
Join Date: May 2010
Location: brentwood, ca
Posts: 4,233
|
Re: Late 31 Tudor Windshield Filler Trim Question
The caged nuts, I believe, were on the 31. Majority of the filler strips I have seen have just the holes. I soldered on a fabricated tab at each end to attach to the pillar where the originals broke off. I slipped the tab into the top of the trim and soldered it in place. Locating the holes and installing caged nuts would take some effort.
|
01-19-2022, 07:23 AM | #4 |
Senior Member
Join Date: Feb 2011
Location: De Pere, WI
Posts: 290
|
Re: Late 31 Tudor Windshield Filler Trim Question
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|