|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-21-2012, 04:15 PM | #1 |
Senior Member
Join Date: May 2010
Location: Ashland KY
Posts: 1,159
|
bearing on king pin location
cant find a drawing anywhere,does the bearing on the front king pins go on top of axle or under the axle? this is on a 35
__________________
DON P |
05-21-2012, 04:19 PM | #2 |
Senior Member
Join Date: May 2010
Location: Solihull, England.
Posts: 8,744
|
Re: bearing on king pin location
On top of the spindle. There should not be room for the bearing between the spindle and the axle. If there is you do not have 35 spindles.
Mart. |
Sponsored Links (Register now to hide all advertisements) |
|
05-21-2012, 06:59 PM | #3 | |
Senior Member
Join Date: May 2010
Location: Yakima Washington
Posts: 913
|
Re: bearing on king pin location
Quote:
On the later models the bearing goes under the axle, puts the load on the bottom of the axle like 51 Merc says. Bill |
|
05-21-2012, 07:01 PM | #4 |
Senior Member
Join Date: May 2010
Location: Ashland KY
Posts: 1,159
|
Re: bearing on king pin location
My axle sets on the bearing,between the spindle bosses.has hydraulic brakes,someone might have put the axle and bp from a later model.when did they start this.I would think the axle should take the load
__________________
DON P |
05-21-2012, 07:12 PM | #5 |
Senior Member
Join Date: May 2010
Location: Dyer, Indiana
Posts: 129
|
Re: bearing on king pin location
Mine are on top of the axle.
|
05-22-2012, 07:34 AM | #6 |
Senior Member
Join Date: May 2010
Location: Lake City Mi.
Posts: 807
|
Re: bearing on king pin location
Sponsored Links (Register now to hide all advertisements)
Gary. |
05-22-2012, 08:20 AM | #7 |
Senior Member
Join Date: May 2010
Location: Altamont, NY
Posts: 1,004
|
Re: bearing on king pin location
Position of the bearing is based upon the spindle used per your application. If you have the original 35 spindles the bearing is positioned on the top of the upper spindle boss and under the king pin brake actuator cup boss. If your vehicle is equipped with later spindles for a hydraulic brake conversion, the bearing mounts between the lower spindle boss and the axle beam boss, cup side pointing downward.
__________________
dickspadaro.com |
05-22-2012, 12:53 PM | #8 |
Senior Member
Join Date: May 2010
Location: Wa.
Posts: 5,406
|
Re: bearing on king pin location
On the early ones, the king pin locking bolt carries the load so you want to be sure they are tight.
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|