|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-11-2017, 08:40 PM | #1 |
Member
Join Date: Dec 2015
Location: Niagara Ontario
Posts: 32
|
Generator detail question
Hi all
I have questions regarding two different generators as shown below: 1) top three photos appear to be from a L1 type based on the end plate and 7/8"nose - does it have the correct front plate ? it is aluminum and the bolt head area is recessed 2) bottom 3 photos are from a generator I picked up at Hershey - it has an aluminum rear plate - non vented and is chamfered at the end - I am unable to find it in the JS or searches here - anyone know any details about it ? Thank you for any replies and I have already learned a lot from this site. John |
10-11-2017, 09:13 PM | #2 |
Senior Member
Join Date: May 2010
Location: St Charles , Missouri
Posts: 1,998
|
Re: Generator detail question
John,
I believe the front aluminum is a 32-34 4-cyl and/or service replacement front cover. Same with the aluminum rear on the lower photos. I an not 100% but hopefully someone else will chime for additional info. thanks, Larry |
Sponsored Links (Register now to hide all advertisements) |
|
10-11-2017, 09:16 PM | #3 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Generator detail question
Pictures 1 and 5 showing the aluminum end plate and beveled end plate are both post Model A production, as are any bodies with 2 wires coming out of a rubber grommet, instead of a stud for the output.
|
10-12-2017, 04:37 AM | #4 |
Member
Join Date: Dec 2015
Location: Niagara Ontario
Posts: 32
|
Re: Generator detail question
Thank you Larry and Tom
The first generator ( top 3 pics) does have the two wires and rubber grommet instead of the post . |
10-12-2017, 04:08 PM | #5 |
Member
Join Date: Dec 2015
Location: Niagara Ontario
Posts: 32
|
Re: Generator detail question
Would it be more correct to put the two aluminum ends on the generator with the two wires coming out the grommet and the later pulley?
|
10-12-2017, 11:13 PM | #6 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Generator detail question
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|