|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-23-2018, 05:02 PM | #1 |
Senior Member
Join Date: Sep 2010
Location: South Coast NSW Australia
Posts: 2,596
|
The best I can get my crab
Bought a vane dizzy setup device last swap.
I am about to pull the crab and check it. Pilot 221 engine, but a USA dizzy, not a pommie one.. It isrunning 12 volts and if I recall, it is still running the original condensor. It had new points. Would like to know what modern condensor I can buy (in OZ preferably) and if I am running a use with resistor coil, what is the best way to go and what type of resistor ? Or is it best to go with a non resisted coil? I am pretty sure I have a full voltage pin on the starter solenoid for cranking. Engine starts and runs fine, and it is only a cruiser,but I suspect it is missing a bit if I give it a bit of pedal at higher RPM. |
05-24-2018, 04:45 AM | #2 |
Senior Member
Join Date: May 2010
Location: tasmania
Posts: 221
|
Re: The best I can get my crab
Sponsored Links (Register now to hide all advertisements)
|
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|