|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-09-2021, 06:18 PM | #1 |
Member
Join Date: Jul 2021
Location: Central Wisconsin
Posts: 31
|
control arm pins
I need to drive the little pins from the control arm from the spark control arms on the steering column. They are tighter than a tick. Any ideas on how to drive them out without bending anything? Thanks!!
|
11-09-2021, 08:28 PM | #2 |
Senior Member
Join Date: May 2010
Location: Georgetown Divide Kelsey ca
Posts: 868
|
Re: control arm pins
A lot of looks but no answers you might try drilling the pins out carefully their most likely rolled over on the ends .
__________________
Dennis in Kelsey ca |
Sponsored Links (Register now to hide all advertisements) |
|
11-09-2021, 08:39 PM | #3 |
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,100
|
Re: control arm pins
3/16 socket 1/4 in drive!hit with hammer to break pins off, then drive pins out!
__________________
www.whidbeymodelaclub.com Last edited by Gary WA; 11-09-2021 at 11:38 PM. |
11-10-2021, 07:52 AM | #4 |
Senior Member
Join Date: May 2021
Location: NH/ VT
Posts: 333
|
Re: control arm pins
|
11-10-2021, 07:57 AM | #5 |
Senior Member
Join Date: May 2010
Location: Grafton,OHIO
Posts: 727
|
Re: control arm pins
Cut off an appropriate size nail and use that to drive them out. worked for me.
|
11-10-2021, 08:25 AM | #6 |
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: control arm pins
Sponsored Links (Register now to hide all advertisements)
|
11-10-2021, 06:08 PM | #7 |
Member
Join Date: Jul 2021
Location: Central Wisconsin
Posts: 31
|
Re: control arm pins
Thanks for the help. I always get good advice here!!! This is a great site!!
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|