Go Back   The Ford Barn > General Discussion > Model A (1928-31)
Reload this Page How to original Radius Ball Cap

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-05-2010, 05:36 AM   #1
atourer
Junior Member
 
atourer's Avatar
 
Join Date: May 2010
Location: Melbourne, Australia
Posts: 17
Default How to original Radius Ball Cap
Guys I am scratching together original radius ball cap parts. Trying experiment not using rubber ball. Have I got the right parts ? Part number 1 & 4 make the best pair fitting in the bellhousing (pic 1 & 2)- Part number 3 has no hope of fitting bellhousing unless modified (pic 3)- is this correct ?. Also when you put them together around the ball there is a gap - the ball diameter is greater than the combined shallows of the caps so problem is the caps do not sit face to face (pic 4) . Am I missing something please ?
Attached Images
File Type: jpg IMG_3585.JPG (78.3 KB, 121 views)
File Type: jpg IMG_3591.JPG (31.8 KB, 93 views)
File Type: jpg IMG_3592.JPG (32.1 KB, 91 views)
File Type: jpg IMG_3596.jpg (16.5 KB, 86 views)
atourer is offline   Reply With Quote
 

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Threaded Mode Threaded Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:54 AM.