Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 06-17-2012, 09:52 PM   #1
29ModelA
Senior Member
 
29ModelA's Avatar
 
Join Date: Jun 2010
Location: Owosso, MI
Posts: 673
Default Does any Vendor have an entire top 'kit'

I need everything for a new top, but do not know what 'everything' is.

This is what I am starting with (photo below). I have a couple restorer books and Clymer restorer books, but none give a breakdown of the parts required.

What you see is what I have (other than a replacement bow for that broken one)

Is the visor needed to get the top installed, as I have not found an original one yet?







__________________
1929 Model A Barn find. California car, just a few more parts to find.

Interior, steering box (rebuild), and I am sure much more!
29ModelA is offline   Reply With Quote
Old 06-18-2012, 06:34 AM   #2
Barry B./ Ma.
Senior Member
 
Barry B./ Ma.'s Avatar
 
Join Date: May 2010
Location: Southbridge, Ma.
Posts: 1,614
Default Re: Does any Vendor have an entire top 'kit'

Get a top kit from LeBaron Bonney. Comes complete with paddng,vinyl covering and instructions.
Barry B./ Ma. is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 06-18-2012, 07:02 AM   #3
Richard Wilson
Senior Member
 
Richard Wilson's Avatar
 
Join Date: May 2010
Location: NC
Posts: 908
Default Re: Does any Vendor have an entire top 'kit'

Even with L-B you have to get the new chicken wire (poultry screen) at the hardware store.
Richard Wilson is offline   Reply With Quote
Old 06-18-2012, 07:28 AM   #4
real550A
Senior Member
 
real550A's Avatar
 
Join Date: Dec 2011
Location: North Branch, MN.
Posts: 161
Default Re: Does any Vendor have an entire top 'kit'

I just did the job with a kit from Mac's. Everything included but the wire. Nice stuff and went well. Patience is the key, and best done when it's warm.... nicer fit.
You'll want the visor installed prior to doing the front hidem strip.
Attached Images
File Type: jpg Top install 002.jpg (96.3 KB, 50 views)
File Type: jpg Top install 003.jpg (36.1 KB, 43 views)
File Type: jpg Top install 004.jpg (41.4 KB, 40 views)
File Type: jpg Top install 005.jpg (80.4 KB, 43 views)
File Type: jpg Top install 006.jpg (82.2 KB, 51 views)
__________________
Mike B.
Model A's and Porsches since 1957
real550A is offline   Reply With Quote
Old 06-18-2012, 07:28 AM   #5
Aerocraft
Senior Member
 
Aerocraft's Avatar
 
Join Date: May 2010
Location: Naperville, IL
Posts: 1,387
Default Re: Does any Vendor have an entire top 'kit'

As I recall, there was also a strip of padding under the poultry netting (the clerk at Farm and Fleet didn't know what chicken wire was) over each of the wooden bows on my '29 Murray Fordor. That material doesn't come in the kit. Check your wooden bows, if there are witness tack holes across the top of the bows, those would have been to hold a small strip pad. The wire is only tacked around the edges. When the vinal is streched across the padding, the padding should not "show" by lifting the vinal up around the edges.

The top can go on without having the visor on your '29 Tudor. I suggest that you clean and paint all the sheet metal under the top material before you install the top.

It has been my experience that, by far, LeBaron Bonney supplys the best top material.

Gar Williams
Aerocraft is offline   Reply With Quote
Old 06-18-2012, 07:43 AM   #6
1931 flamingo
Senior Member
 
1931 flamingo's Avatar
 
Join Date: May 2010
Location: new britain,ct 06052
Posts: 9,390
Default Re: Does any Vendor have an entire top 'kit'

Sponsored Links (Register now to hide all advertisements)
I didn't think the chicken wire was there from the "factory"??
Paul in CT
1931 flamingo is offline   Reply With Quote
Old 06-18-2012, 08:27 AM   #7
jburessr
Member
 
Join Date: Aug 2011
Location: Baltimore Md.
Posts: 53
Default Re: Does any Vendor have an entire top 'kit'

Go to Bratton's, He has top quality material and he can answer any questions you may have. L B is junk!!!!!!!!!! And they don't want to talk to you after they have your money!!!!!!!
jburessr is offline   Reply With Quote
Old 06-18-2012, 09:02 AM   #8
real550A
Senior Member
 
real550A's Avatar
 
Join Date: Dec 2011
Location: North Branch, MN.
Posts: 161
Default Re: Does any Vendor have an entire top 'kit'

I didn't think the chicken wire was there from the "factory"??

There seems to be some question on the coupes. I think some had it, some didn't.
I left it in, as my car is going to be driven, and it adds a lot of support to the roof system. This car had had a roof replacement years ago, so it may have been added then.
__________________
Mike B.
Model A's and Porsches since 1957
real550A is offline   Reply With Quote
Old 06-18-2012, 10:05 AM   #9
Marco Tahtaras
Senior Member
 
Marco Tahtaras's Avatar
 
Join Date: May 2010
Posts: 3,099
Default Re: Does any Vendor have an entire top 'kit'

I think the link below will answer a number of questions.

Installing a closed car roof
__________________
http://www.abarnyard.com/
Marco Tahtaras is offline   Reply With Quote
Old 06-18-2012, 10:51 AM   #10
real550A
Senior Member
 
real550A's Avatar
 
Join Date: Dec 2011
Location: North Branch, MN.
Posts: 161
Default Re: Does any Vendor have an entire top 'kit'

Thanks Marco! I used this as a guide to my installation.
__________________
Mike B.
Model A's and Porsches since 1957
real550A is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:40 PM.