|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-15-2014, 01:45 PM | #1 |
Senior Member
Join Date: Jun 2010
Location: Maryville,Tn
Posts: 302
|
Pressing Hub Bolts
I have the stud installation tool from Snyder and a 30 ton press...is there a jig that can be bought or maybe made to hold the hub while pressing the studs?
|
11-15-2014, 01:54 PM | #2 |
Senior Member
Join Date: May 2010
Location: Van, Texas
Posts: 1,122
|
Re: Pressing Hub Bolts
I had to build my own jig. Hand holding the hub and drum gets very risky. Hub and drum have to be very tight to one another and both MUST be kept perpendicluar to the stud. Stud Very square to the pressure from the press. Just a little bit lopsided and you get a lopsided stud or worse yet a cracked drum or hub.
|
Sponsored Links (Register now to hide all advertisements) |
|
11-15-2014, 02:21 PM | #3 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Pressing Hub Bolts
I believe it was Don Turley that made and sold some nice holders for swaging wheel studs.
Maybe a search would turn up a picture of one. |
11-15-2014, 02:49 PM | #4 |
Senior Member
Join Date: May 2010
Location: Southern Maine
Posts: 1,497
|
Re: Pressing Hub Bolts
1930 Coupe, That is a very nice looking tool. I'm jealous
|
11-15-2014, 02:54 PM | #5 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,741
|
Re: Pressing Hub Bolts
Sponsored Links (Register now to hide all advertisements)
http://www.fordgarage.com/pages/swaging.htm Bob |
|
|
Sponsored Links (Register now to hide all advertisements) |
|