|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-02-2018, 10:42 AM | #1 |
Member
Join Date: Jul 2013
Posts: 93
|
36 cam timing gear question
I have a '36 LB that has an aluminum press on cam gear. The match marks aren't aligned perfectly but they are very close. The misalignment is probably about the width of the line. Will this create a noticeable problem?
|
11-02-2018, 12:54 PM | #2 |
Senior Member
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,834
|
Re: 36 cam timing gear question
No.You'll not notice any problem
__________________
Unfortunately, two half wits don't make a whole wit! |
Sponsored Links (Register now to hide all advertisements) |
|
11-02-2018, 01:40 PM | #3 |
Senior Member
Join Date: May 2010
Location: Chester Vt
Posts: 8,860
|
Re: 36 cam timing gear question
I always check for split over lap, wnen both valves are open at the same time at TDC. The may vary alittle but it works OK.
|
11-02-2018, 03:11 PM | #4 |
Member
Join Date: Jul 2013
Posts: 93
|
Re: 36 cam timing gear question
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|