|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-20-2020, 12:48 PM | #1 |
Member
Join Date: Feb 2017
Posts: 37
|
40 Ford Convertible Header
Does anyone have any pics of the bottom of the header with the top material installed?
Greatly appreciated Frank |
11-20-2020, 12:53 PM | #2 |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,935
|
Re: 40 Ford Convertible Header
Frank, The material was wrapped around the header with the "cut ends" positioned within the recess. Subsequently, the rubber seal was installed in the slot which covered the loose ends and nails.
__________________
"I can explain it for you. However, I can't understand it for you". |
Sponsored Links (Register now to hide all advertisements) |
|
11-20-2020, 01:05 PM | #3 |
Member
Join Date: Feb 2017
Posts: 37
|
Re: 40 Ford Convertible Header
Thanks Mike
I havent bought the top yet so not sure about your answer. The top material is cutout to fit in the recesses for the locks and top irons? Wish I had a pics. |
11-20-2020, 01:15 PM | #4 | |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 8,935
|
Re: 40 Ford Convertible Header
Quote:
The rear wood bow as well as the #3 (steel) bow do not get covered. The material you typically get is not cut to fit. That's something the installer is expected to do.
__________________
"I can explain it for you. However, I can't understand it for you". |
|
11-20-2020, 03:04 PM | #5 |
Member
Join Date: Feb 2017
Posts: 37
|
Re: 40 Ford Convertible Header
Sponsored Links (Register now to hide all advertisements)
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|