Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-01-2020, 06:41 AM   #1
Steve Rinaldo
Member
 
Join Date: May 2010
Posts: 89
Default Radius Ball Service

I have just finished doing a service on my 1930. One of the things I did was to tighten up the two radius ball nuts. I checked a lot of the books and previous post about the proper procedure and found a bunch of ways to do it.. The reason for this was I had a slight steering wheel shake between 50-55 mph. I tightened the nuts until they hit the sleeve and then backed them off until I could insert the cotter pin. I drove the car and the shake was gone. My question, is the procedure that I used the normal one that is used?
Thanks, Steve
Steve Rinaldo is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:11 AM.