|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-09-2020, 05:03 PM | #1 |
Senior Member
Join Date: Sep 2010
Location: michigan
Posts: 1,126
|
Finishes of bolts
I am a little confused about the proper finish for valve cover bolts?
I would anticipate ! NOT assume that unfinished is correct, but I also have seen raven or black are both correct ? for February of 1929 ? Thank you for your help ! Joe. |
10-09-2020, 06:27 PM | #2 |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: Finishes of bolts
According to the MARC/MAFCA Restoration Guidelines and Judging Standards, page 1-18 Revised 2016, they are UNFINISHED all years.
But plain UNFINISHED bolts, nuts and lock washers will rust in time. So what I do is clean them up super good till they shine. Then spray two coats of VHT Satin Clear paint on them and let them dry. This stuff dries hard. So far, so good. Pluck |
Sponsored Links (Register now to hide all advertisements) |
|
10-09-2020, 07:23 PM | #3 |
Senior Member
Join Date: Sep 2010
Location: michigan
Posts: 1,126
|
Re: Finishes of bolts
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|