|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-25-2021, 08:58 PM | #1 |
Member
Join Date: Jul 2010
Location: Wagga Wagga - Australia
Posts: 78
|
fuel shutoff Early 28
i want to clean up the threads on my early 28 fuel shutoff valve.
I know these are a pipe thread. Can anyone let me know the die sizes, I would need for the three threads on the shutoff. Thanks Dave |
11-26-2021, 05:18 AM | #2 |
Senior Member
Join Date: May 2010
Location: Victoria, Australia
Posts: 1,176
|
Re: fuel shutoff Early 28
Being a USA product, they would be an NPT thread. BSPT is similar, but still different enough that if you use a BSPT threading tool, you will never seal it properly.
|
Sponsored Links (Register now to hide all advertisements) |
|
11-26-2021, 01:22 PM | #3 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,043
|
Re: fuel shutoff Early 28
The thread that goes into the fuel tank is 1/4" NPT (National Pipe Taper)18 TPI (threads per inch).
The thread where the fuel line attaches is 5/8"-18 A thread file can be used to clean up the male threads: https://www.amazon.com/General-Tools...82&sr=8-9&th=1 Also see: http://fittingsandadapters.com/threadchart.html
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! Last edited by katy; 11-26-2021 at 08:40 PM. Reason: Correction |
11-27-2021, 01:53 AM | #4 |
Member
Join Date: Jul 2010
Location: Wagga Wagga - Australia
Posts: 78
|
Re: fuel shutoff Early 28
Sponsored Links (Register now to hide all advertisements)
I was able to get it sorted out. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|