|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
07-02-2012, 05:06 PM
|
#1 |
|
Senior Member
Join Date: Jun 2011
Location: Dallas, Texas
Posts: 109
 |
Mains and rods gaps.
I'm putting an engine back together. I forgot what the main and rod cap clearances should be for the plasti-gage.
|
|
|
|
07-02-2012, 05:24 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Largo Florida
Posts: 7,225
|
Re: Mains and rods gaps.
.001-.0015" ,, not over .002".. plasti-gauge [green .001-.003"]
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
07-02-2012, 09:04 PM
|
#3 |
|
Senior Member
Join Date: May 2010
Location: Spruce Pine, NC
Posts: 1,458
|
Re: Mains and rods gaps.
Sponsored Links (Register now to hide all advertisements)
use .002" of heavy aluminum foil and the go-no-go method. easier and more accurate.
__________________
our next Model A is out there in the unknown...... |
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:12 AM.