|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-20-2022, 11:25 AM | #1 |
Senior Member
Join Date: Mar 2018
Location: Arkansas
Posts: 525
|
56 door hinge torque?
Anyone know what the torque is for the hinge to frame and hinge to door is? Cannot seem to find it anywhere if there even was a torque reading for it. Also would you use blue locktite on the bolts? Thanks
|
04-20-2022, 03:36 PM | #2 |
Senior Member
Join Date: May 2010
Location: Granite City, Illinois
Posts: 3,008
|
Re: 56 door hinge torque?
There is no need to use locktite on any of the original body bolts having the nubbed washer-heads, or the normal hex-heads with nubbed or serrated washers. Total overkill. These bolts will not back out without force.
I have always used a 1/4" drive socket set to torque the door hinge bolts down. The socket wrench handle is only 5 inches long. You can get the bolts plenty tight using a 1/4 inch drive socket without the need for any torque wrench. They've never loosened up. Last edited by Daves55Sedan; 04-22-2022 at 12:06 AM. |
Sponsored Links (Register now to hide all advertisements) |
|
04-20-2022, 05:28 PM | #3 |
Senior Member
Join Date: Mar 2018
Location: Arkansas
Posts: 525
|
Re: 56 door hinge torque?
1/8" sockets? Smallest I have are 1/4".
|
04-20-2022, 07:15 PM | #4 |
Senior Member
Join Date: Aug 2012
Location: IN A 'GALAXIE' FAR FAR AWAY
Posts: 6,485
|
Re: 56 door hinge torque?
I think Dave means 3/8" DRIVE.
__________________
***** We should have a contest. The player has to start at the very last post of a thread & then try to guess what the OP's original question was about ... |
04-20-2022, 07:36 PM | #5 |
Senior Member
Join Date: May 2010
Location: Midland Park, NJ
Posts: 3,982
|
Re: 56 door hinge torque?
Google torque specs to find the specs on different size bolts and use that as a guide for the size bolts you have..
__________________
48 Ford Conv 56 Tbird 54 Ford Victoria |
04-22-2022, 12:06 AM | #6 |
Senior Member
Join Date: May 2010
Location: Granite City, Illinois
Posts: 3,008
|
Re: 56 door hinge torque?
Sponsored Links (Register now to hide all advertisements)
For removal of any stubborn bolts, I use a socket drive set one size larger than the bolt thread diameter, but for installation of new or clean used bolts and nuts, I use one size smaller. So, for a 5/16" thread, 1/4 inch drive is what I use. |
04-22-2022, 10:43 AM | #7 |
Senior Member
Join Date: Nov 2016
Location: Now on the Land of Sun City West, AZ
Posts: 405
|
Re: 56 door hinge torque?
It's 15lbs for both sides per Shop Manual.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|