|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-28-2015, 01:37 PM | #1 |
Senior Member
Join Date: Oct 2010
Location: North Pole, Alaska
Posts: 1,470
|
30 coupe window regulators
Finally got my side glass in, glass fits good. The regulators are another story, my left one was hitting the glass channel so I trimmed the back portion that sticks out. Works ok, but the right is worse, still hits even after trimming. Is my door possibly bent in on the inner panel, or are these just poorly made regulators?
BTW these are Ford Authorized parts, made in Taiwan, and I already had to weld the right one because the arm rivets popped out the first time I turned it. |
08-28-2015, 01:55 PM | #2 |
Senior Member
Join Date: Nov 2010
Location: Anchorage, Alaska
Posts: 9,115
|
Re: 30 coupe window regulators
Snyder's has a better window regulator. I replaced the Taiwan unit that was in my PU when I bought it with the Snyder unit and it now works soooooooooooo much better!
__________________
Alaskan A's Antique Auto Mushers of Alaska Model A Ford Club of America Model A Restorers Club Antique Automobile Club of America Mullins Owner's Club |
Sponsored Links (Register now to hide all advertisements) |
|
08-28-2015, 04:08 PM | #3 |
Senior Member
Join Date: Oct 2010
Location: North Pole, Alaska
Posts: 1,470
|
Re: 30 coupe window regulators
Thanks, I think these were from Macs, I bought them about a year and a half ago. Since Macs was taken over I kinda been ordering from other sources.
|
08-28-2015, 06:35 PM | #4 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: 30 coupe window regulators
The "rivet" that slides in the bottom window lift channel does NOT turn on my 29 Tudor. They are meant to slide, but not rotate.
|
08-28-2015, 08:40 PM | #5 |
Senior Member
Join Date: Oct 2010
Location: North Pole, Alaska
Posts: 1,470
|
Re: 30 coupe window regulators
Yes, sure seems like it would work better if it rolled.
|
08-28-2015, 08:50 PM | #6 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: 30 coupe window regulators
Sponsored Links (Register now to hide all advertisements)
|
08-28-2015, 09:45 PM | #7 |
Senior Member
Join Date: May 2010
Location: Innisfil, Ontario Canada
Posts: 1,174
|
Re: 30 coupe window regulators
Yes I had the same problem on a 30 Coupe. I had to grind the back of the roller down and weld it in. Then grind it smooth to get the clearance. I think I also bent the arm a bit. Remember "Aftermarket" means "Almost Fits"
John Poole |
|
|
Sponsored Links (Register now to hide all advertisements) |
|