!941 Ford Coupe vent Window

[albjerryg]

Is it possible to have a glass cut to fill the opening of the vent window and window there by eliminating the vent window?? Sorry that is for the front and passenger door ??THANKS Jerry

[fordwife]

I'm not sure about '41, but in'46 some models had a rear vent window that did not open. I don't know if the rubber seal is still available for these models. Check with some of the suppliers.

[mrtexas]

Originally Posted by albjerryg

Is it possible to have a glass cut to fill the opening of the vent window and window there by eliminating the vent window?? THANKS Jerry

I did this on my 49 wagon. 49 wagon rubber is not reproduced. I used some u shaped window channel which I already had from replacing the rear window channel and wrapped it around the glass.

Untitled by philip sauber, on Flickr

[albjerryg]

So if I understand you put a permanent glass in the vent that use to pivot. I was thinking of a glass that would roll up and down and cover the window and vent window area? Thanks Jerry

[JSeery]

So your wanting to make it like say a 38/39 door window?

[albjerryg]

Sponsored Links (Register now to hide all advertisements)

Yes exactly but I am sure that window want fit a 1941???I guess. Thanks Jerry

[woodiewagon46]

If I'm reading your question correctly you want to remove the vent window and have a one piece glass. A lot of hot rodders do this, so I would ask the question on the HAMB. A couple of companies that come to mind are Specialty Power Window and Electric-Life. I don't know if your stock crank style equipment will be able to handle a larger window and you will have to fabricate a track for the front of the door.

[albjerryg]

OK thanks for the info and I will contact them. Jerry

[albjerryg]

Does any one know the dimensions of the 1938 Ford coupe front door window glass< ?Thanks Jerry