|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
06-23-2019, 05:50 PM
|
#1 |
|
Senior Member
Join Date: Jan 2011
Location: sw minnesota
Posts: 4,567
|
48 6 cyl bell housing
is this a 6cyl bell? measures 3 3/4 thick, and all my other cast iron v8 ones (as in the red &blue motor pic ) measure 3" thick. i am not a 6 expert and wish to verify that there are no other variations before this gets shipped out. this is in regards to the posts last week in which the gentleman wishes to swap out a 4spd for a 3 spd, and his current bell, while correct, is damaged. thanks, skip
Last edited by cas3; 06-23-2019 at 05:53 PM. Reason: no pics |
|
|
|
06-23-2019, 07:24 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,741
|
Re: 48 6 cyl bell housing
I measured the one I have and it's 3 3/4" also.
Bob |
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
06-23-2019, 09:36 PM
|
#3 |
|
Senior Member
Join Date: Jan 2011
Location: sw minnesota
Posts: 4,567
|
Re: 48 6 cyl bell housing
thank you bob
|
|
|
|
|
06-24-2019, 07:17 PM
|
#4 |
|
Senior Member
Join Date: Apr 2015
Location: NC
Posts: 273
|
Re: 48 6 cyl bell housing
Isn't that a pu truck bellhousing?
|
|
|
|
|
06-24-2019, 08:02 PM
|
#5 | |
|
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,741
|
Re: 48 6 cyl bell housing
Sponsored Links (Register now to hide all advertisements)
Quote:
Yes. |
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:49 AM.