|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-26-2022, 10:41 PM | #1 |
Junior Member
Join Date: May 2022
Posts: 10
|
I Need Help Please with some repair advice
Replaced ignition switch on my 31 Model A Roadster and now the car will not start (it started before with the old one)
I have spark at the points and then smoke is coming out below the point set inside of the distributor for some reason. Can someone help me with the wiring route from the switch to coil to distributor not sure if I've crossed something or not.... Any help would be greatly appreciated, thanks! Lamar Green is online now Report Post |
05-26-2022, 11:37 PM | #2 |
Senior Member
Join Date: Jun 2010
Location: Danvers, Ma.
Posts: 712
|
Re: I Need Help Please with some repair advice
"Sounds" like you may have the wiring correct but the ignition cable has been screwed into dist. body a bit too far and bent the contact inside. You'll need to remove upper dist. plate to get at the bent contact and straighten it out a bit. Then should redo the timing, since the cam needs to come off. Hope this helps.
|
Sponsored Links (Register now to hide all advertisements) |
|
05-27-2022, 05:14 AM | #3 |
Junior Member
Join Date: May 2022
Posts: 10
|
Re: I Need Help Please with some repair advice
Can you walk me through how to set the timing correctly please
|
05-27-2022, 06:46 AM | #4 |
Senior Member
Join Date: May 2010
Location: Long Island, NY
Posts: 3,463
|
Re: I Need Help Please with some repair advice
Take heed of these slides:
__________________
Bob Bidonde |
05-27-2022, 10:42 AM | #5 |
Senior Member
Join Date: Jun 2015
Location: Red Deer, Alberta
Posts: 5,042
|
Re: I Need Help Please with some repair advice
Model A Ford instruction manual, page 23
https://img1.wsimg.com/blobby/go/170...=1653177760110
__________________
If you don't hear a rumor by 10 AM, start one!. Got my education out behind the barn! |
05-27-2022, 12:16 PM | #6 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,907
|
Re: I Need Help Please with some repair advice
Sponsored Links (Register now to hide all advertisements)
A fuse block mounted at the starter will prevent all the smoke from coming out of your wires. They only put so much into them and once you let it all out things don't work anymore.
__________________
Dave / Lincoln Nebraska |
05-28-2022, 11:37 AM | #7 |
Senior Member
Join Date: Jun 2010
Location: Temecula, CA
Posts: 4,085
|
Re: I Need Help Please with some repair advice
I hope you saved all of the smoke, it is expensive to replace!
|
05-28-2022, 07:47 PM | #8 |
Senior Member
Join Date: Dec 2014
Location: Shawnee, Ok
Posts: 3,471
|
Re: I Need Help Please with some repair advice
The wires on the back of the switch can ground out on the gas tank, I solved this issue by using several layers of electrical tape behind the switch on the gas tank.
__________________
Keith Shawnee OK '31 SW 160-B |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|