Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 12-28-2018, 07:48 PM   #1
AD1948Ford
Senior Member
 
Join Date: Dec 2015
Location: Houston, Texas
Posts: 110
Default 48 Ford passenger tail light wiring issue

In need of some help. I recently installed and hooked up a new dash dimmer switch, license plate light and hooked up the sending unit. In doing so, i unhooked the tail light wires and re-routed the wires in the proper location. Prior to do all this, my tail lights and brake lights worked. Now I have headlights (normal and brights), brake lights but no dash lights, license plate light or tail lights when the switch is pulled out.

What could be the issue? Bad connections? Bad ground on tail light housing?

Any help would be appreciated.


Aaron
AD1948Ford is offline   Reply With Quote
Old 12-28-2018, 08:01 PM   #2
Bob C
Senior Member
 
Join Date: May 2010
Location: So Cal
Posts: 8,751
Default Re: 48 Ford passenger tail light wiring issue

Looking at the wiring diagram the tail, license, and dash light all come from
the black wire on the light switch. That's where I would start looking.
Bob C is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 12-28-2018, 09:06 PM   #3
AD1948Ford
Senior Member
 
Join Date: Dec 2015
Location: Houston, Texas
Posts: 110
Default Re: 48 Ford passenger tail light wiring issue

Sponsored Links (Register now to hide all advertisements)
Thank you, Bob. You were spot on. One of my connector sleeves must of gave out. I replaced it and boom, everything works.
AD1948Ford is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:56 AM.