|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-28-2013, 08:34 PM | #1 |
Senior Member
Join Date: Feb 2011
Location: Chicopee, MA
Posts: 1,402
|
Waddingtons Sheetmetal in Australia as an Alternative??
I was referred to this site to check out the sheetmetal pieces for my 29 Closed Cab Pickup.
I think, but will call Sacramento Vintage Ford to see if they carry such parts, I know they offer the Truck Cab Waddingtons builds. http://waddingtons.myshopify.com/ The AUD $ is higher than the US $ so we will get the parts bit cheaper than on the Website. Anyone have anymore information to share? |
07-29-2013, 01:55 AM | #2 |
Senior Member
Join Date: May 2010
Location: Qld, Australia
Posts: 4,221
|
Re: Waddingtons Sheetmetal in Australia as an Alternative??
I used some of their parts on my 28 ccpu.
The door hinges,panel under the front windscreen, and tee strips on the rear of the cab. Tee strips were the wrong type and went up in the shelf. Door hinges were OK and needed to be cut to fit(was advised of this) fitted OK. Panel under the front screen,fitted good. I would have bought a whole cab from them, but they would not sell less the tank and firewall. I think they make Good parts Lawrie |
Sponsored Links (Register now to hide all advertisements) |
|
07-29-2013, 02:39 AM | #3 |
Senior Member
Join Date: Sep 2010
Location: South Coast NSW Australia
Posts: 2,596
|
Re: Waddingtons Sheetmetal in Australia as an Alternative??
They do some good special prices at Bendigo swap each november.
I usually get a bit of stuff off them then. |
07-29-2013, 03:54 PM | #4 |
Senior Member
Join Date: Feb 2011
Location: Chicopee, MA
Posts: 1,402
|
Re: Waddingtons Sheetmetal in Australia as an Alternative??
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|