|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
12-05-2020, 06:57 PM
|
#1 |
|
Senior Member
Join Date: Sep 2019
Location: Kountze,TX
Posts: 313
|
Bad Stud thread
Trying to finish my spare engine and was torquing the head nuts. Everything went fine at 25ft lbs, 36 ft lbs, 48 ft lbs, and then finishing up at 55 ft lbs and the threads failed on #14 on the chart!!! Damn, now I gotta pull the head and helicoil that hole. Worst part is wasting the new head gasket!
|
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 02:24 AM.