|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-18-2020, 05:54 PM | #1 |
Senior Member
Join Date: May 2010
Posts: 212
|
31 Slant W/S sedan rear bumpers
What size risers are required on the brackets, 4-1/2" or 5-1/4" ?
Thanks, Mark Last edited by tirekicker; 10-18-2020 at 06:31 PM. |
10-18-2020, 07:03 PM | #2 |
Senior Member
Join Date: Jun 2015
Posts: 1,414
|
Re: 31 Slant W/S sedan rear bumpers
Our SW measures 5 1/4" from top to hole center. Better get some others' input also because I've seen a different spec but can't locate the source.
|
Sponsored Links (Register now to hide all advertisements) |
|
10-18-2020, 07:12 PM | #3 |
Senior Member
Join Date: Jun 2015
Location: Signal Mtn, TN (SE TN)
Posts: 2,371
|
Re: 31 Slant W/S sedan rear bumpers
Marco has a diagram that shows all rear bumpers dimensions
I’ll try to post it in a few days when I get to a desktop Also one could go to Marco’s Barnyard it should be there |
10-18-2020, 07:21 PM | #4 |
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: 31 Slant W/S sedan rear bumpers
on my 160A the stand is 4 3/4" from the top to the center of the rivet. like Bill said you want to make sure you have the correct rear bumper irons. they are longer then most other Model A`s
|
10-18-2020, 07:58 PM | #5 |
Senior Member
Join Date: May 2010
Location: Glendale, AZ
Posts: 2,952
|
Re: 31 Slant W/S sedan rear bumpers
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|