|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-22-2021, 11:05 AM | #1 |
Senior Member
Join Date: May 2010
Location: Glendale, AZ
Posts: 2,953
|
Panel Delivery Rear door handle help needed
...
A friend of mine is in need of help. He has a Panel Delivery truck and is ready to install the rear door handle but has problems connecting the inside door locking system. What is he missing. Pictures show what he has. All help appreciated Joop .. Last edited by Joop; 05-22-2021 at 01:55 PM. |
05-22-2021, 02:27 PM | #2 |
Senior Member
Join Date: Dec 2014
Location: Shawnee, Ok
Posts: 3,471
|
Re: Panel Delivery Rear door handle help needed
Looks like the handle shaft is a little short, can't get the locking C-clip on.
Should that inside plate be recessed into the door? I don't know Is there a piece missing? I don't know All I do know is that what is shown looks pretty good, how about a pic of the rest of the car?
__________________
Keith Shawnee OK '31 SW 160-B |
Sponsored Links (Register now to hide all advertisements) |
|
05-22-2021, 05:39 PM | #3 |
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Re: Panel Delivery Rear door handle help needed
These are photos of the handle assembly on my 1931 Panel. A bit different.
Hope they help
__________________
Bob from Northport Northport, Michigan Last edited by Bob from Northport; 01-24-2022 at 09:39 PM. |
05-22-2021, 06:48 PM | #4 |
Senior Member
Join Date: May 2010
Location: Glendale, AZ
Posts: 2,953
|
Re: Panel Delivery Rear door handle help needed
THanks Bob
|
05-23-2021, 07:59 AM | #5 |
Senior Member
Join Date: May 2010
Location: Glendale, AZ
Posts: 2,953
|
Re: Panel Delivery Rear door handle help needed
Anymore help out there.
|
05-23-2021, 08:25 AM | #6 |
Senior Member
Join Date: Jun 2010
Posts: 640
|
Re: Panel Delivery Rear door handle help needed
Sponsored Links (Register now to hide all advertisements)
You might forward question & photos to Jim Dix, who restored a '29 Panel. (607)562-3711 [email protected] jb |
05-23-2021, 10:36 AM | #7 |
Senior Member
Join Date: Jun 2015
Posts: 1,414
|
Re: Panel Delivery Rear door handle help needed
Rubber pad under escutcheon too thick? There were no phillips head screws used originally so perhaps back plate isn't set correctly or could be recessed as suggested ? Also, those handles are not available so don't change the shaft length, etc. The Nov 2015 issue of the Restorer Mag. has an article about the '31 Panel and shows a different inside latch assembly with an outside T locking handle that may be shorter shaft length.
Last edited by duke36; 05-23-2021 at 10:43 AM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|