|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-09-2015, 01:27 PM | #1 |
Senior Member
Join Date: May 2010
Location: middle of Iowa
Posts: 632
|
'32 front wheel seals - watcha use?
Is there anything more modern that you guys are using for the front wheel seals? Is there a thin rubber lipped seal that will fit in there?
|
03-09-2015, 01:42 PM | #2 |
Senior Member
Join Date: May 2010
Location: middle of Iowa
Posts: 632
|
Re: '32 front wheel seals - watcha use?
And another question: Are the big spindle nuts thicker on a '32 than a '48? I stole some bearings, washers, and nuts from a '48 to mock up this '32, and the nuts don't reach all the way out to the cotter pin hole in the end of the spindle.
|
Sponsored Links (Register now to hide all advertisements) |
|
03-09-2015, 09:58 PM | #3 |
Senior Member
Join Date: May 2010
Location: near Washington, DC
Posts: 558
|
Re: '32 front wheel seals - watcha use?
Sponsored Links (Register now to hide all advertisements)
__________________
Those who do not move do not die, but are they not already dead? |
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|