|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-21-2017, 05:56 AM | #1 |
Senior Member
Join Date: Dec 2010
Location: Rockville, Maryland
Posts: 350
|
Floor Board Screw Question
I need to chase the threads for my floorboard screws are the screws 12-24? seems to be tight????
__________________
Chuck McDonald, Member of AACA, Model A Club, NRA |
08-21-2017, 06:09 AM | #2 |
Senior Member
Join Date: Aug 2014
Posts: 438
|
Re: Floor Board Screw Question
yes, 12-24
|
Sponsored Links (Register now to hide all advertisements) |
|
08-21-2017, 09:48 PM | #3 |
Senior Member
Join Date: May 2016
Location: Scottsdale, Arizona
Posts: 612
|
Re: Floor Board Screw Question
Shoot a bit of brake cleaner into each hole and then a bit of engine oil and then chase the holes. They are most likely full of rust and dirt...a bit cleaned out and they will chase just fine. Also open the holes in the floor boards with a 5/16 drill and the floor boards will go back in much easier...Ernie
|
08-22-2017, 04:45 AM | #4 |
Senior Member
Join Date: Dec 2010
Location: Rockville, Maryland
Posts: 350
|
Re: Floor Board Screw Question
Sponsored Links (Register now to hide all advertisements)
__________________
Chuck McDonald, Member of AACA, Model A Club, NRA |
|
|
Sponsored Links (Register now to hide all advertisements) |
|