|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-30-2017, 09:01 AM | #21 |
Senior Member
Join Date: May 2010
Posts: 203
|
Re: 32 K member identification
You are right rotorwrench . I did have the major parts cut on a plasma table and the larger one bend on a large brake. I have a small brake for the legs etc. . If I wanted to "make money I would have to sell them for $900-$1000.
|
12-30-2017, 10:41 AM | #22 |
Senior Member
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 16,436
|
Re: 32 K member identification
I believe that! I don't know how much a set of dies would cost for a high tonage press but a newly pressed one would likely cost just as much or more. As long as there are originals still around even for $850, folks wouldn't likely go that route.
|
Sponsored Links (Register now to hide all advertisements) |
|
12-30-2017, 11:00 AM | #23 |
Senior Member
Join Date: May 2010
Location: Solihull, England.
Posts: 8,755
|
Re: 32 K member identification
^^ Excellent work, Stumpjumper.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|