|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-12-2018, 02:58 PM | #1 |
Senior Member
Join Date: Dec 2010
Location: Nor*Cal
Posts: 720
|
Anyone have a pic of the proper routing for a 1935 p/c speedo cable
Routing my speedo cable on my 1935 it a has later tranny and pedal (39) wondering whats the best route.
Thanks
__________________
Throttle Benders Est. 1949
|
04-13-2018, 02:19 PM | #2 |
Senior Member
Join Date: May 2010
Location: Up North
Posts: 623
|
Re: Anyone have a pic of the proper routing for a 1935 p/c speedo cable
There is a good picture in the 1935-1936 Ford Book that the V-8 Club sells. I just ran mine in my 1936 pickup. It is stock so this may not apply for your changes.
Connect the cable to the 'turtle' on the torque tube. Then run it through the first hole in the cross member. Along the edge of the bottom of the cross member should be a hole in which a B-9295 (with bolt, lock washer and nut) clip holds it to the frame. From there it goes to the hole in the cowl and into the body. It should be held in place to the cowl insulator by two more B-9295 clips and machine screws and flat washers. |
Sponsored Links (Register now to hide all advertisements) |
|
04-13-2018, 03:32 PM | #3 |
Senior Member
Join Date: Mar 2014
Location: Jacksonville FL
Posts: 3,927
|
Re: Anyone have a pic of the proper routing for a 1935 p/c speedo cable
Here is from the 35/36 club book
|
04-13-2018, 03:45 PM | #4 |
Senior Member
Join Date: May 2010
Location: Irving, Texas
Posts: 598
|
Re: Anyone have a pic of the proper routing for a 1935 p/c speedo cable
Here is the routing on my 36.
|
04-13-2018, 06:20 PM | #5 |
Senior Member
Join Date: Dec 2010
Location: Nor*Cal
Posts: 720
|
Re: Anyone have a pic of the proper routing for a 1935 p/c speedo cable
Sponsored Links (Register now to hide all advertisements)
__________________
Throttle Benders Est. 1949
|
Thread Tools | |
Display Modes | |
|
|
Sponsored Links (Register now to hide all advertisements) |
|