|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-01-2015, 08:53 PM | #1 |
Member
Join Date: Mar 2013
Location: Ft.Mill, south carolina
Posts: 52
|
Windshield Wiper Motor Installation HELP
Hi All
I have a August 28 Tudor with a new windshield. I just purchased a rebuilt Owen-Dyneto wiper motor. Because my windshield is new it does not have any holes. Can anybody provide measurements on exactly where I should drill the holes in the top of the windshield frame? It appears there would be two holes for the mounting bolts (one on either side)and then one for the switch lever and one for the hand operating lever. Is that right? Any help would be greatly appreciated. Randy |
05-01-2015, 09:13 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,750
|
Re: Windshield Wiper Motor Installation HELP
Marco posted this picture.
Bob |
Sponsored Links (Register now to hide all advertisements) |
|
05-01-2015, 09:40 PM | #3 |
Senior Member
Join Date: May 2010
Posts: 160
|
Re: Windshield Wiper Motor Installation HELP
If you have the correct wiper motor for your car: an OD-C1B with the offset wiper shaft, then Marco diagram doesn"t apply.
|
05-02-2015, 06:43 AM | #4 |
Senior Member
Join Date: May 2010
Location: Mid Shenandoah Valley Va,
Posts: 268
|
Re: Windshield Wiper Motor Installation HELP
Sponsored Links (Register now to hide all advertisements)
Thanks Warren |
|
|
Sponsored Links (Register now to hide all advertisements) |
|