|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-30-2012, 04:16 PM | #1 |
Junior Member
Join Date: Jun 2012
Location: Evansville wi
Posts: 15
|
Engine questions
Im doing some work on my engine right now and i have two questions. The first is that on the top of the block its stamped .060 does that mean its bored out? The second is to deal with the babbitt bearings, the middle main has some defects, can u tell me if it is still good. The engine ran when i took it out of the truck and the rest of the bearings are good.
|
06-30-2012, 04:30 PM | #2 |
Senior Member
Join Date: Jun 2012
Posts: 559
|
Re: Engine questions
I would not run it with that main looking like that. It appears to be rather chunky with loose pieces.
__________________
1928 Model A Business Coupe Rebuild picture gallery here The light at the end of the tunnel has been turned off due to budget cuts. |
Sponsored Links (Register now to hide all advertisements) |
|
06-30-2012, 04:33 PM | #3 |
Senior Member
|
Re: Engine questions
I'm going to bed before work so short answers, yes, no.
__________________
What's right about America is that although we have a mess of problems, we have great capacity - intellect and resources - to do some thing about them. - Henry Ford II |
06-30-2012, 04:39 PM | #4 |
Junior Member
Join Date: Jun 2012
Location: Evansville wi
Posts: 15
|
Re: Engine questions
Thanks for the answers! Does any one know any one who does babbitt near southern Wisconsin and how much do u think it will cost?
|
06-30-2012, 07:54 PM | #5 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: Engine questions
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|