|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
06-29-2012, 07:46 PM | #1 |
Senior Member
Join Date: May 2010
Location: Lynden, Wa
Posts: 3,552
|
measuring VR output
Hi all,
I went searching but could not find out how to measure if the VR is charging. I installed a new Bat. and followed the directions of the man. (funconcepts) but the ammeter does not show a charge. The directions are roughly as follows: -Move third brush counterclockwise start car with lights on and bring to a high rev. I should see a 7-9 amp discharge. RESULT: 6 amp drop. -Move third brush clockwise until I get a 8-11 amp charge. RESULT: 0 charge and 6 amp discharge with lights on. I did not proceed as I did not want to run the bat. down. I figure I can check the voltage at the bat. and then the amps at the junction box. Am I missing something here? I am not an electrical guru by any stretch of the imagination. Mike
__________________
1930 TownSedan (Briggs) 1957 Country Sedan |
06-30-2012, 08:33 AM | #2 |
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
|
Re: measuring VR output
I assume when you say VR you mean voltage regulator. A voltage reulator doesn't charge, it only controls the charge from the generator. Did the generator work OK, before the regulator was installed? Have you talked to John Regan about it?
|
Sponsored Links (Register now to hide all advertisements) |
|
06-30-2012, 11:47 AM | #3 |
Senior Member
Join Date: May 2010
Location: Lynden, Wa
Posts: 3,552
|
Re: measuring VR output
Sponsored Links (Register now to hide all advertisements)
Mike
__________________
1930 TownSedan (Briggs) 1957 Country Sedan |
|
|
Sponsored Links (Register now to hide all advertisements) |
|